Disassembling And Assembling; Hydraulic Pump - wsm M108S Workshop Manual

M108S, WSM

[2] DISASSEMBLING AND ASSEMBLING

(1) Hydraulic Pump

Removing Hydraulic Pump
1. Remove the floor mat (1) and inspection plate under the mat.
2. Remove the seat (2) and floor cover (3).
3. Disconnect the delivery pipe 1 (4) and delivery pipe (5).
4. Remove the lowering speed adjusting rod (6).
5. Disconnect the parking brake cable (7).
6. Disconnect the PTO clutch cable (8).
7. Disconnect the suction pipes (11) and PTO pipe (12).
8. Remove the pump base (9) with gear pumps.
9. Remove the hydraulic pump (13) from pump base (9).
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of transmission case and pump base, and pump base and
hydraulic pump.
• Replace the oil pipes (10) with new ones.
• Apply oil to oil pipes (10).
• Be sure to check the PTO clutch lever movement.
Delivery pipe 1 and 2
retaining nut
Tightening torque Pump base mounting nut
Hydraulic pump mounting
screw
(1) Floor Mat
(2) Seat
(3) Floor Cover
(4) Delivery Pipe 1
(5) Delivery Pipe 2
(6) Lowering Speed Adjusting Rod
(7) Parking Brake Cable
8-S11
HYDRAULIC SYSTEM
108 to 117 N·m
11 to 12 kgf·m
79.6 to 86.7 lbf·ft
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
(8) PTO Clutch Cable
(9) Pump Base
(10) Pipe
(11) Suction Pipe
(12) PTO Pipe
(13) Hydraulic Pump for Power Steering
(14) Hydraulic Pump for Three-Point
Hitch
W1032179
KiSC issued 05, 2012 A