wsm M108S Workshop Manual page 271

M108S, WSM
Counter Shaft
1. Tap out the counter shaft (1) to front through the hole of clutch
hub (2).
2. Remove the external snap ring (3), then tap in the clutch hub (2)
with bearing to the clutch housing.
(When reassembling)
• Be sure to direct the groove side of the thrust collar.
• Apply transmission fluid to the external snap ring.
• Be sure to change the external snap ring with new one.
• Be sure to check the counter shaft rotation smoothly after
assembling the support.
• After assembling support, be sure to check the thrust excess play
on the counter shaft of gear.
• Be sure to assembling the needle bearing (6) with narrow width
to inside.
(1) Counter Shaft
(2) Clutch Hub
(3) External Snap Ring
(4) Shim
(5) Needle Bearing (Wide)
3-S25
TRANSMISSION
(6) Needle Bearing (Narrow)
(7) Bearing Support
(8) Clutch Housing
(A) Tapping
W1028579
KiSC issued 05, 2012 A