Disassembling Clutch Housing - wsm M108S Workshop Manual

M108S, WSM

[4] DISASSEMBLING CLUTCH HOUSING

Bearing Support and Main Shaft
1. Remove the bearing retainers (1).
2. Remove the external snap ring (2).
3. Tap out the main shaft (6) to the rear.
4. Remove the bearing support (5) by M8 x Pitch 1.25 screws into
holes (A), (B).
NOTE
• When tapping out the main shaft (6), hold the bearing
washer (8) needle bearing (3), collar (7) and shims (4) for
prevent the drop.
(When reassembling)
• Be sure to direct the groove side of the thrust collar.
• Apply transmission fluid to the bearing.
• Be sure to change the external snap ring.
• Be sure to check the main shaft rotation smoothly after
assembling the support.
• After assembling support, be sure to check the side clearance on
the main shaft of gears.
section.)
Bearing retainer mounting
screw
Tightening torque
Bearing support mounting
screw
(1) Bearing Retainer
(2) External Snap Ring
(3) Needle Bearing
(4) Shim
(5) Bearing Support
(6) Main Shaft
3-S24
TRANSMISSION
(Refer to "6. SERVICING" in this
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
(7) Collar
(8) Bearing Washer
(9) Thrust Washer
(A) Hole
(B) Hole
W1027124
KiSC issued 05, 2012 A