wsm M108S Workshop Manual page 347

M108S, WSM
Bevel Gear Case
1. Separate the bevel gear case (3) from front wheel case (4).
2. Remove the front wheel case support (1).
3. Loosen the bearing retainer (2) mounting screws.
4. Remove the bearing retainer (2) by screwing M8 screw into holes
A and B.
5. Remove the external snap ring (8).
6. Draw out the bevel gear (7) and bevel gear shaft (9).
7. Take out the shim (5).
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to the
bevel gear case.
• Apply grease to the front wheel case support DX bushing and
front wheel case DX bushing.
• Install the oil seal to the front case support so that its lip faces the
outward.
• Apply gear oil to the bearing.
IMPORTANT
• Be sure to adjust the kingpin pivot. (Refer to "[1] CHECKING
AND ADJUSTING" in this section.)
Front wheel case support
mounting screw (M14, 9T)
Tightening torque
Bearing retainer mounting
screw
(1) Front Wheel Case Support
(2) Bearing Retainer
(3) Bevel Gear Case
(4) Front Wheel Case
(5) Shim
(6) Bearing
Front Wheel Case Cover
1. Remove the front wheel case cover from the front wheel case by
screwing M10 screws into hole A and B.
(When reassembling)
• Apply grease to the O-ring.
Front wheel case cover
Tightening torque
mounting screw
6-S11
FRONT AXLE
167 to 196 N·m
17.0 to 20.0 kgf·m
123 to 144 lbf·ft
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
(7) Bevel Gear
(8) External Snap Ring
(9) Bevel Gear Shaft
A : Hole
B : Hole
W1016334
48 to 55 N·m
4.9 to 5.7 kgf·m
36 to 41 lbf·ft
W1017129
KiSC issued 05, 2012 A