wsm M108S Workshop Manual page 163

M108S, WSM
Camshaft and Balancer Shaft
1. Remove the camshaft position pulsar gear (1).
2. Remove the camshaft set screws and draw out the camshaft (2).
3. Remove the balancer shaft 1 set screws and draw out the
balancer shaft 1 (3).
4. Remove the balancer shaft 2 set screws and draw out the
balancer shaft 2 (4).
(When reassembling)
• When installing the balancer shaft 1 and 2, be sure to place the
4th cylinder piston at the top dead center in compression then,
align all mating marks on each gear to assemble the timing
gears, set the idle gear last.
Camshaft set screw
Tightening torque Balancer shaft set screw
Camshaft position pulsar
gear mounting screw
(1) Camshaft Position Pulsar Gear
(2) Camshaft
(3) Balancer Shaft 1
(4) Balancer Shaft 2
1-S40
ENGINE
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
4.7 to 5.6 N·m
0.48 to 0.58 kgf·m
3.5 to 4.1 lbf·ft
(5) Idle Gear 1
(6) Crank Gear
(7) Idle Gear 2
W1191037
KiSC issued 05, 2012 A