wsm M108S Workshop Manual page 153

M108S, WSM
Intake Air Temperature Sensor
1. Remove the intake air temperature sensor (1).
(When reassembling)
• Replace the gasket with new one.
Intake air temperature
Tightening torque
sensor
(1) Intake Air Temperature Sensor
Intake Air Pressure Sensor
IMPORTANT
• When you disconnect the intake air pressure hose from the
intake air pressure sensor, be careful not to damage the
intake air pressure sensor.
1. Disconnect the intake air pressure hose (3) from the intake air
pressure sensor (2).
2. Remove the intake air pressure sensor mounting screws (1).
3. Remove the intake air pressure sensor (2).
(When reassembling)
• If the intake air pressure hose is damage, replace the hose with
new one.
(1) Intake Air Pressure Sensor Mounting
Screw
Coupler of Injector Harness
1. Remove the screw (1).
2. Draw out the coupler of injector harness (2) from the cylinder
head cover 2 (3).
3. Disconnect the coupler of injector harness from the injector
harness (4).
IMPORTANT
• Be careful not to damage the harness when you draw out the
coupler.
(When reassembling)
• Replace the O-ring with new one.
(1) Screw
(2) Coupler of Injector Harness
(3) Cylinder Head Cover 2
1-S30
ENGINE
30 to 39 N·m
3.0 to 4.0 kgf·m
22 to 28 lbf·ft
W1090361
(2) Intake Air Pressure Sensor
(3) Intake Air Pressure Hose
W1090756
(4) Injector Harness
(5) O-ring
W1091591
KiSC issued 05, 2012 A