wsm M108S Workshop Manual page 517

M108S, WSM
Hub Plate
1. Three stopper bolts (1) are set in stopper magnet clutch (2) at the
position corresponding to the shape of compressor. (Refer to "8.
SPECIAL TOOLS" at "G. GENERAL" section.)
2. The stopper magnet clutch (2) is hung on hub plate (3) and it is
fixed that the compressor rotates.
3. Remove the magnetic clutch mounting screw.
4. Remove the hub plate (3) and air gap adjustment shim (4).
(When reassembling)
• Do not apply grease or oil on the hub plate facing.
• Do not use the magnetic clutch mounting screw again.
• It is confirmed to turn rotor by hand after assembling and not
contact with stator and hub plate.
• Check and adjust the air gap before tight the magnet clutch
mounting screw to the specified torque.
SERVICING" in this section.)
Magnetic clutch mounting
Tightening torque
screw
(1) Stopper Bolt
(2) Stopper Magnet Clutch
Rotor
1. Remove the external circlip (1).
2. Remove the rotor (2).
(When reassembling)
• Do not use the external circlip again.
• Assemble the external circlip for the tapered side to become
outside of rotor.
• The width of expanding of external circlip is set in boss of shaft
as a minimum.
(Reference)
• Code No. for external circlip : T1065-87450
(1) External Circlip
Stator
1. Remove the lead wire (6) from compressor body.
2. Remove the external circlip (2).
3. Remove the stator (1).
(When reassembling)
• Do not use the external circlip again.
• Assemble the external circlip for the tapered side to become
outside of front housing.
• The width of expanding of external circlip is set is boss of shaft
as a minimum.
• Match and assemble the concave part (4) of the front housing (3)
and the pin (5) of stator.
(Reference)
• Code No. for external circlip : T1065-87440
(1) Stator
(2) External Circlip
(3) Front Housing
10-S40
(Refer to "[3]
15.0 to 21.0 N·m
1.5 to 2.1 kgf·m
11.1 to 15.5 lbf·ft
(3) Hub Plate
(4) Shim
W1059166
(2) Rotor
W1059753
(4) Concave Part
(5) Pin
(6) Lead Wire
W1059953
KiSC issued 05, 2012 A
CABIN