wsm M108S Workshop Manual page 322

M108S, WSM
Brake Test
1. Remove the bleeder from brake case and set the hydraulic brake
adaptor (Code No. 07916-52970) (1), joint (Code No. 07916-
50401) (2), cable (Code No. 07916-50331) (3) and pressure
gauge (Code No. 07916-52961) (4).
2. Set the pedal fixing plate between the pedal and pedal stopper
after depressing the brake pedal to reach the pressure between
2.95 to 3.23 MPa (30.0 to 33.0 kgf/cm
3. Read the pressure P after one minute.
4. After reading the pressure P, wait another five minutes to read
the pressure P' and check the pressure drop. The pressure drop
should be within P x 0.1 MPa (P x 0.1 kgf/cm
5. If the pressure drop is too big, attach the pressure gauge to
equalizer (brake pipe rear end) and master cylinder (brake pipe
front end) to find out the problem area.
CAUTION
• If the air is in the master cylinder, brake pipe and case, bleed
the air completely.
(1) Hydraulic Brake Adaptor
(2) Joint
Brake Disc Thickness
1. Remove the checking plug (1) of brake disc thickness at brake
case.
2. Press the brake pedal and measure the clearance A between two
brake discs by the thickness gauge.
3. If the measurement is less than the allowable limit, replace the
brake disc.
Clearance between two
Allowable limit
brake discs (A)
(1) Checking Plug
5-S6
BRAKES
2
, 427 to 469 psi).
2
, P x 0.1 psi).
(3) Cable
(4) Pressure Gauge
W1013769
3.3 mm
0.13 in.
A : Clearance between two brake
discs
W1014210
KiSC issued 05, 2012 A