Removing Brake Case - wsm M108S Workshop Manual

M108S, WSM

(3) Removing Brake Case

Draining Transmission Fluid
1. Place oil pan underneath the transmission case.
2. Remove the drain plugs (1).
3. Drain the transmission fluid.
4. Reinstall the drain plugs (1).
(When reassembling)
• Fill up from filling port (3) after removing the filling plug up to the
upper notch on the dipstick (2).
• After running the engine for few minutes, stop it and check the
fluid level again, add the fluid to prescribed level if it is not correct
level.
Capacity Transmission fluid
IMPORTANT
• Use only KUBOTA SUPER UDT fluid. Use of other oil may
damage the transmission or hydraulic system.
• Refer to "4. LUBRICANTS, FUEL AND COOLANT" at "G.
GENERAL" section.
• Do not mixed different brands fluid together.
(1) Drain Plug
(2) Dipstick
(3) Filling Port
Draining Fuel
(When remove the brake case LH)
1. Place an oil pan under the right side fuel tank (1).
2. Remove the drain cover (2).
3. Drain the fuel.
(When reassembling)
• Be sure to fix the O-ring (3) on the drain cover (2).
• Bleed the fuel system.
IMPORTANT
• The fuel tank is made of plastic.
Be careful not to over tighten the screws.
(1) Fuel Tank
(2) Drain Cover
5-S11
BRAKES
60.0 L
63.4 U.S.qts
52.7 Imp.qts
A : Oil level is acceptable with this
range.
W1018368
(3) O-ring
(4) Screw
W1018408
KiSC issued 05, 2012 A