Disassembling And Assembling; Removing Brake Pedal - wsm M108S Workshop Manual

M108S, WSM

[2] DISASSEMBLING AND ASSEMBLING

(1) Removing Brake Pedal

Brake Pedal
1. Remove the meter panel.
2. Remove the bonnet rear.
3. Remove the brake pedal return spring and clevis pin from the
turnbuckle of master cylinder.
4. Remove the circlip (4) and spring pin (5) and draw out the brake
pedal shaft (1), then remove the left and right brake pedal (2), (3).
(When reassembling)
• Apply small amount grease to the brake pedal bearings (6).
IMPORTANT
• After reassembling the brake pedals, be sure to adjust the
brake pedal free travel.
(1) Brake Pedal Shaft
(2) Brake Pedal (LH)
(3) Brake Pedal (RH)
5-S8
BRAKES
(4) Circlip
(5) Spring Pin
(6) Brake Pedal Bearing
W1015227
KiSC issued 05, 2012 A