Wheel Hub; Tire Pressure - wsm M108S Workshop Manual

M108S, WSM

[3] WHEEL HUB

[4] TIRE PRESSURE

CAUTION
• Do not attempt to mount a tire. This should be done by a qualified person with the proper equipment.
IMPORTANT
• Do not use tires larger than specified.
• When you intend to mount different size of tires from equipped ones, consult your distributor about front
drive gear ratio for detail.
• Excessive wear of tires may occur due to improper gear ratio.
Screw circle diameter
(A)
Number of screws
Screws
Hub pilot diameter (B)
Through the tire pressure is factory-set to the prescribed level, it
naturally drops slowly in the course of time. Thus, check it every day
and inflate as necessary.
To inflate the wheel tires, use an air compressor or hand pump.
Recommended Inflation Pressure
• Maintain the pressure shown below for normal use.
Tire sizes
9.5 L - 15
10.00 - 16, 6PR
Front 12.4 - 24, 6PR
13.6 - 24, 6PR
13.6R24
16.9 - 34, 6PR
18.4 - 34
Rear 18.4R34
18.4-30
18.4R30
NOTE
• Maintain the maximum pressure in front tires, if using a front
loader of when equipped with a full load of front weights.
(A) Insufficient
(B) Standard
G-69
Front wheel hub Rear wheel hub
203.2 mm (8 in.) 203.2 mm (8 in.)
8
M16 x P1.5
152.4 mm (6 in.) 152.4 mm (6 in.)
Inflation pressure
250 kPa (2.5 kgf/cm
220 kPa (2.2 kgf/cm
170 kPa (1.7 kgf/cm
150 kPa (1.5 kgf/cm
160 kPa (1.6 kgf/cm
120 kPa (1.2 kgf/cm
140 kPa (1.4 kgf/cm
120 kPa (1.2 kgf/cm
110 kPa (1.1 kgf/cm
110 kPa (1.1 kgf/cm
(C) Excessive
(D) Ground
KiSC issued 05, 2012 A
G GENERAL
8
M16 x P1.5
W1043392
2
, 36 psi)
2
, 32 psi)
2
, 24 psi)
2
, 22 psi)
2
, 23 psi)
2
, 18 psi)
2
, 20 psi)
2
, 18 psi)
2
, 16 psi)
2
, 16 psi)
W1027488