wsm M108S Workshop Manual page 393

M108S, WSM
Adjusting Position Control Lever
1. Attach a weight of approx. 490 N (50 kgf, 110 lbf) to the end of
the lower links.
2. Start the engine and set the speed at 1000 min
3. Move the draft control lever (2) all the way down and shift the
position control lever (1) downward by approx. 20 mm (0.79 in.)
(A) from the lever guide upper end.
4. Loosen the lock nut (4), then turn the position control shaft (3)
with an open end wrench so as to adjust the offset within the
factory specifications (Refer to "[1] CHECKING
ADJUSTING" in this section). Tighten the lock nut (4) securely.
5. Secure the position control lever (1) all the way down position to
check that the floating range can be obtained.
(Reference)
• The specification of the floating range (a) is 20.0 to 40.0 mm
(0.788 to 1.57 in.) from lever guide lower end.
If the floating range (a) is not within the specification, readjust the
"Adjusting Position Control Lever".
Length A Factory spec.
(1) Position Control Lever
(2) Draft Control Lever
(3) Position Control Shaft
(4) Lock Nut
8-S8
HYDRAULIC SYSTEM
-1
(rpm).
20 to 30 mm
0.79 to 1.1 in.
a : Floating Range
b : Down
c : Deep
d : Position Range
e : Shallow
f : Draft Range
g : Up
W1029592
KiSC issued 05, 2012 A
AND