M108S, WSM
[3] THRUST CLEARANCE ON SHAFT
Checking side clearance on Main Shaft Gear
1. Measure the side clearance between thrust bearing and bearing
washer.
2. If the measurement is not within the factory specifications, adjust
the clearance with shim on the front end of main shaft.
(Reference)
• Thickness of shim (4)
0.2 mm (0.0079 in.) [Code No. 3F740-28420]
0.3 mm (0.0118 in.) [Code No. 3F740-28410]
0.5 mm (0.0197 in.) [Code No. 3F740-28440]
Side clearance between
thrust bearing and
Factory spec.
bearing washer
(1) Main Shaft
(2) Thrust Bearing
Checking side clearance on Counter Shaft
1. Measure the side clearance between 33T gear (1) and collar (2).
2. If the measurement is not within the factory specifications, adjust
the clearance with shim on the front end of counter shaft.
(Reference)
• Thickness of shims
0.2 mm (0.0079 in.) [Code No. 3F740-28420]
0.3 mm (0.0118 in.) [Code No. 3F740-28410]
0.5 mm (0.0197 in.) [Code No. 3F740-28430]
Side clearance between
Factory spec.
33T gear and collar
(1) 33T Gear
(2) Collar
3-S40
TRANSMISSION
0.1 to 0.3 mm
0.004 to 0.01 in.
(3) Bearing Washer
(4) Shim
W1043048
0.1 to 0.3 mm
0.004 to 0.01 in.
(3) Counter Shaft
(4) Shim
W1044496
KiSC issued 05, 2012 A