wsm M108S Workshop Manual page 429

M108S, WSM
LIGHTING SYSTEM
Symptom
Head Light Does Not
Light
Illumination Light
Does Not Light
Tail Light Does Not
Light
Hazard Light Does
Not Light
Hazard and Turn
Signal Indicator
Lamp Does Not Light
Hazard and Turn
Signal Light Does
Not Go ON and OFF
Work Light Does Not
Light
Probable Cause
Fuse blown
Bulb blown
Wiring harness disconnected or improperly
connected (between main switch B terminal and
combination switch B1 terminal, between
combination switch 1 terminal and head light,
between combination switch 2 terminal and head
light)
Fuse blown
Bulb blown
Wiring harness disconnected or improperly
connected (between combination switch T
terminal and panel board)
Fuse blown
Wiring harness disconnected or improperly
connected (between combination switch T
terminal and tail light)
Fuse blown
Bulb blown
Flasher unit defective
Hazard switch defective
Turn signal switch defective
Bulb blown
Wiring harness disconnected or improperly
connected
Flasher unit defective
Fuse blown
Bulb blown
Wiring harness disconnected or improperly
connected (between starter motor B terminal
and work light)
Replace
Replace
Repair or replace
Replace
Replace
Repair or replace
Replace
Repair or replace
Replace
Replace
Replace
Replace
Replace
Replace
Repair or replace
Replace
Replace
Replace
Repair or replace
9-S3
ELECTRICAL SYSTEM
Reference
Solution
Page
9-S11, 12
–
–
9-S11, 12
G-41
–
9-S11, 12
–
9-S11, 12
–
9-S23
9-S22
9-S21
–
–
9-S22
9-S11, 12
–
–
W1011496
KiSC issued 05, 2012 A