Starter Relay And Heater Relay; Relays (Pto Safety, Work Light, Auxiliary Power And A/C Compressor) - wsm M108S Workshop Manual

M108S, WSM
[8] RELAYS

(1) Starter Relay and Heater Relay

Checking Connector Voltage
1. Measure the voltage with a voltmeter across the battery terminal
and chassis as table below.
2. If the voltage differs from the battery voltage, the wiring harness
or fuse is faulty.
ROPS
Starter
and Terminal d – Chassis
relay
CABIN
(1) Starter Relay
Functional Check
NOTE
• The relays described here are used same ones so that these
are interchangeable.
1. Apply battery voltage across the terminals c and d, and check for
continuity across the terminals a and b.
2. If continuity is not established across the terminals a and b,
replace it.
(1) Connector (Relay)
9-S25
ELECTRICAL SYSTEM
Approx. battery voltage
(2) Connector (Wire Harness)
W1043116
(2) Battery
W1036849
KiSC issued 05, 2012 A