Hazard Switch - wsm M108S Workshop Manual

M108S, WSM

(2) Hazard Switch

Checking Connector Voltage
1. Connect the battery negative code, then measure the voltage
with a voltmeter across the terminal a and chassis.
2. If the voltage differ from the battery voltage, the wiring harness is
faulty.
Voltage Terminal a – Chassis
(1) Hazard Switch
Checking Hazard Switch Continuity
1. Measure the resistance with ohmmeter across the terminal a and
terminal c, and across the terminal d and terminal e.
2. If the measurement is not following below, the hazard switch or
the bulb are faulty.
Resistance
Terminal a – Terminal c
(Switch at OFF)
Resistance
Terminal a – Terminal c
(Switch at ON)
Resistance
Terminal d – Terminal e
(Bulb)
(1) Hazard Switch
9-S22
ELECTRICAL SYSTEM
Approx. battery voltage
(2) 6P Connector (Wire Harness Side)
W1033077
Infinity
0 Ω
Approx. 13 Ω
(2) Bulb
W1047271
KiSC issued 05, 2012 A