Dual Speed (Ds Model Only) - wsm M108S Workshop Manual

M108S, WSM

(3) Dual Speed (DS Model Only)

Dual Speed Indicator
1. Remove the indicator (1) from the side panel.
2. Check the continuity with an ohmmeter across the indicator
terminals.
3. If value is indicated, the bulb is faulty.
(1) Indicator
Dual Speed Switch
1. Remove the dual speed switch connector (2).
2. Check the continuity with an ohmmeter across the switch
terminals.
3. If it does not conduct or any value is indicated when the switch is
pushed, the switch is faulty.
Whenever the DS switch button is pushed, the switch repeats
turning ON and turning OFF.
4. If infinity is not indicated when the switch is pushed to the OFF
position, the switch is faulty.
Resistance
Resistance
(Across switch terminal)
(1) Dual Speed Switch
Connector Voltage
1. Disconnect the dual speed valve wire harness connector (1).
2. Turn the main switch to the ON position.
3. Measure the voltage with a voltmeter across the yellow color lead
with wire harness and chassis when DS switch button is pushed
ON position.
4. If the voltage differs from the battery voltage, the wiring harness
or fuse is faulty.
DS switch at ON (LO)
Voltage
DS switch at OFF (HI)
(1) Connector
9-S33
ELECTRICAL SYSTEM
W1028688
ON
0 Ω
condition
OFF
Infinity
condition
(2) Connector
W1029124
Approx. battery voltage
0 V
(2) DS Valve
W1029532
KiSC issued 05, 2012 A