Remove The Old Battery; Installing The New Battery; Reconnecting The Battery To The Device - AMX MVP-9000i-GB Instruction Manual

Interior of MVP-9000i, including female battery connector
FIG. 121

Remove the old battery

Remove the two screws holding the battery case to the back cover. Carefully remove the battery from the back cover.
Please dispose of the battery in a proper fashion as required by municipal or federal regulations

Installing the new battery

1. Open the plastic bag containing the MVP-BP-9 kit, taking care not to use sharp instruments near the battery itself.
2. Remove the protective film on the battery case. DO NOT install the battery without removing this film.
3. Attach the new battery to the back cover, either using the two screws used to hold the previous battery to the cover or with
the two replacement screws included with the MVP-BP-9 kit.

Reconnecting the battery to the device

1. On the back cover, make sure that the battery connector wiring runs to the left.
2. Make sure to seat fully the battery plug to the connector in the device (FIG. 121). If fingers cannot be used, use a clean,
nonconductive stick or probe to seat the connectors.
3. Reattach the back of the device, engaging the ledge at the bottom of the device and using it to swing the back down into place.
NOTE: When reassembling the device, take especial care not to pinch or squeeze the connector wiring or the battery. Do not
force the back cover onto the device, as this can damage the device.
4. Insert the seven screws and replace the rubber feet atop the two upper screws, using the replacement rubber feet included in
the Battery Pack Kit. Replace the bottom label over the three bottom screws, using the replacement label included in the
Battery Pack Kit (FIG. 122).
Rear of the MVP-9000i-WH
FIG. 122
5. Slide the IR emitter cover back into place over the emitter until it clicks.
6. Restart the device to confirm that the new battery is functioning correctly.
NOTE: Please dispose of the old battery in a proper fashion as required by municipal or federal regulations.
MVP-9000i - Instruction Manual
Rubber feet
IR Emitter Cover
Battery (shown on
device for clarity)
Battery connector
Battery lead
.
Position of replacement label
Battery Life and Replacement
138