Miscellaneous Mvp Strings; Undock-<User; Undocked; Swap - AMX MVP-9000i-GB Instruction Manual

"^" Button Commands (Cont.)

^WLD

Miscellaneous MVP Strings

The following two strings are sent by the MVP panel back to the communicating Master:
MVP Strings to Master
undock-<user> This is sent to the target Master when the MVP undock button (or the docking station undock button) is pressed and a

UNDOCKED

SWAP

dock

MVP Panel Lock Passcode Commands

These commands are used to maintain a passcode list. With the MVP-9000i, a password must be entered to remove the panel from
the Wall Docking Station. Only the passcode is entered. The user entry is just for identifying the passcodes.
MVP Panel Lock Passcode Commands

^LPC

^LPR

MVP-9000i - Instruction Manual
Controls the behavior of the panel LED
Syntax:
^WLD,<LED NUM>,<ACTION>,<VALUE>
Variables:
<LED NUM> indicates the channel code or ID number.
0-RED
1-BLUE
2-GREEN
<ACTION> indicates the expected behavior of the LED.
0 - LED OFF: Turns LED Off
1 - LED ON: Turns LED On
2 - LED Resume: Restores operation of LED.
3 - LOW BRIGHTNESS: Sets the low brightness value for LED when operating on battery.
4 - HIGH BRIGHTNESS: Sets the high brightness value for LED when operating on external power or docked.
5 - En/Disable Blink: Enable LED blinking
6 - En/Disable Fade: Transitions from high/low are smooth
7 - Set Color: Set the tri-color LED to one of the supported NetLinx colors (Yellow, Orange, VeryLightCyan, etc...)
valid password is entered (if password is set up).
• If the panel has no information within the User Access Passwords list, 'none' is sent as a user.
• If the undock button in the System & Panel Options page (page 56) is used, 'setup' is sent.
This is sent when the panel is physically removed from the dock.
This is sent after a panel swaps successfully from Wired to Wireless or from Wireless to Wired. A successful swap occurs
when there is not an offline and then online event from the transition.
This is sent to the target Master when the MVP is docked.
Clear all users from the User Access Passwords list on the Password Setup page.
Syntax:
"'^LPC'"
Example:
SEND_COMMAND Panel,"'^LPC'"
Clear all users from the User Access Password list on the Password Setup page.
Remove a given user from the User Access Passwords list on the Password Setup page.
Syntax:
"'^LPR-<user>'"
Variable:
user = 1 - 50 ASCII characters.
Example:
SEND_COMMAND Panel,"'^LPR-Robert'"
Remove user named 'Robert' from the User Access Password list on the Password Setup page.
Programming
120