5.
Remove the five screws from the back of the device (FIG. 123).
Two screws under upper screw covers
FIG. 123
Placement of screws on the back of the MVP-9000i
Two of the screws are at the upper corners of the device, underneath rubber feet that also act as screw covers.
Remove the rubber feet to access the screws.
Lift up the kickstand and remove the label to reach the remaining three screws.
6.
Discharge all static electricity that may have built up on your body, either by using a static discharge strap or by
touching a nearby piece of metal.
7.
Carefully remove the back of the device and detach the battery lead at the battery connector (FIG. 124). This will
allow the back cover to be detached from the device.
FIG. 124
Interior of MVP-9000i, including female battery connector
Remove the old battery
1.
Remove the two screws holding the battery case to the back cover. Carefully remove the battery from the back
cover. Please dispose of the battery in a proper fashion as required by municipal or federal regulations
Installing the new battery
1.
Open the plastic bag containing the MVP-BP-9 kit, taking care not to use sharp instruments near the battery itself.
2.
Remove the protective film on the battery case. DO NOT install the battery without removing this film.
3.
Attach the new battery to the back cover, either using the two screws used to hold the previous battery to the cover
or with the two replacement screws included with the MVP-BP-9 kit.
Reconnecting the battery to the device
1.
On the back cover, make sure that the battery connector wiring runs to the left.
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
3 screws under label
(beneath kickstand)
Battery Life and Replacement
Battery (shown on
device for clarity)
Battery connector
Battery lead
.
167