Recharging; Using The Usb Ports; Undocking The Touch Panel; Cleaning The Mvp-Tds-9 - AMX MVP-9000i-GB Instruction Manual

To input port on
the MVP-TDS-9
MVP-TDS-9 cable
FIG. 7
To connect the MVP-TDS-9 to the PS-POE-AT via the special Ethernet cable:
1. Connect the terminal end of the cable to the PWR connector on the bottom of the MVP-TDS-9.
2. To prevent wear on the power supply cord and assure that the device's base is in full contact with the table surface, press the
cord into the locking groove running across the bottom of the device (FIG. 8).
3. The other end of the included Ethernet cable has an input port, intended for a standard RJ45 jack. Use a standard Ethernet
cable to connect the Ethernet/PoE port to the PS-POE-AT plugging the other end of the Ethernet cable into the Data & Power
Out RJ45 port on the PS-POE-AT. Make sure that the PS-POE-AT's power cable is connected to the device and to an available
power source, and that the incoming Ethernet cable accessing the Data In RJ45 jack is connected to the desired network.
4. Place the touch panel in the Docking Station cradle, guiding it into place with the locking grooves on each side of the cradle
(FIG. 8). When fully seated, the touch panel's Docking Station connector should be in contact with the Docking Station's
charger pins.

Recharging

To recharge the MVP-9000i, slide the device into the Table Docking Station cradle bottom-first and make sure the device is fully
seated in the Docking Station. The charger pins in the bottom of the cradle (FIG. 8) must be in contact with the connector on the
bottom of the MVP-9000i for it to start recharging. The MVP panel will stop recharging automatically once the battery has achieved
its maximum charge.
MVP-TDS-9-GW Table Docking Station - Rear
FIG. 8

Using the USB ports

The MVP-TDS-9 has two USB ports on the left of the device behind the Docking Station cradle (FIG. 8). These ports may be used for
transferring files to the MVP-9000i, as well as ports for USB-powered accessories.

Undocking the Touch Panel

For information on removing a touch panel locked into the MVP-TDS-9, please refer to the Undocking from the MVP-TDS-9 or MVP-
WDS-9 on page 28.

Cleaning the MVP-TDS-9

You should clean the MVP-TDS-9 Table Docking Station after each day's use to maintain the device's appearance. Always use a clean
cotton cloth and a spray bottle containing water or a non-ammonia-based cleaner, as alcohol-based cleaners can damage the
device. Do not directly spray the device: instead, spray the cloth to prevent moisture from collecting on the charger pins. Do NOT
use an abrasive of any type to clean the Table Docking Station, as this may permanently damage or remove the device's finish.
MVP-9000i - Instruction Manual
To Ethernet cable connected
to PS-POE-AT
Docking Station cradle
Charging Pins
USB ports (2)
Locking groove
Accessories
22