System Settings - Wired; System Settings - Wifi - AMX MVP-9000i-GB Instruction Manual

System Settings - Wired

Use the options on the Wired Tab (FIG. 70) to configure communication settings for Ethernet communication with the MVP-9000i.
System Settings - Wired Tab
FIG. 70
System Settings - Wired Tab
Back:
WiFi/Wired icon:
Connection Status
icon:
DHCP/STATIC:
IP Address:
Subnet Mask:
Gateway:
Host Name:
Primary DNS:
Secondary DNS:
Domain:
MAC Address
NOTE: If the touch panel will not be used in a docking station, or if the docking station will not have network connectivity (i.e., if the
docking station is being used only to charge the device), using the default DHCP setting for the wired interface is highly
recommended. Conf iguring a static IP address on the Wired Settings page without network connectivity may lead to a loss of
connection.

System Settings - WiFi

The options on the Systems Settings - WiFi tab (FIG. 71) include the wireless security methods supported by the WiFi card. These
security methods incorporate WPA, WPA2, and EAP technology, some of which require the upload of unique certificate files to a
target panel. Refer to the Appendix B: Wireless Technology section on page 180 for further information.
System Settings - WiFi Tab
FIG. 71
:
MVP-9000i - Instruction Manual
Saves all changes and returns to the previous page.
The icon to the left of the Connection Status Icon displays whether the current connection to the Master is Wireless
(image of a radio antenna) or Wired (image of three networked computers).
The icon in the upper-right corner of each Protected Setup page provides a constant visual indication of current
connection status.
Note: a Lock appears on the icon if the panel is connected to a secured NetLinx Master.
Sets the panel to either DHCP or Static communication modes.
• DHCP - a temporary IP Addresses is assigned to the panel by a DHCP server. If DHCP is selected, the other IP
Settings fields are disabled (see below).
• Static IP is a permanent IP Address assigned to the panel. If Static IP is selected, the other IP Settings fields are
enabled (see below).
This is the IP address for this panel.
This is the subnet mask for this panel.
This is the gateway address for this panel.
This is the host name for this panel.
This is the address of the primary DNS server used by this panel for host name lookups.
This is the secondary DNS address for this panel.
This is a domain name to the panel for DNS look-up.
This unique address identifies the wireless Ethernet card in the panel (read-only).
Protected Setup Pages
59