System Settings - Usb; Calibrate Page - AMX MVP-9000i-GB Instruction Manual

System Settings - USB

The USB tab (FIG. 85) controls the ability for the MVP-9000i to connect to a network via a USB connection.
System Settings page - USB tab
FIG. 85
System Settings - USB Tab
Back:
WiFi/Wired icon:
Connection Status
icon:
DHCP/Static:
IP Address:
Subnet Mask

Calibrate Page

The Calibrate page (FIG. 86) allows you to calibrate the touch panel for accurate button selection.
Calibrate page
FIG. 86
1. From the Protected Setup page, touch the Calibration button to open the Calibrate page.
NOTE: The Calibrate page may also be accessed by holding the lower left capacitive touch button and the directional pad for 6
seconds, or by pressing the Reset button on the left side of the device for 9 seconds.
2. Press the crosshairs in turn. If the crosshairs are not touched within ten seconds, the MVP-9000i will return to the Protected
Setup page.
3. The page will read "Calibration Successful. Touch to continue." Touch anywhere on the screen to return to the Protected Setup
page.
NOTE: If the screen is not touched at that point, the device will automatically return to the Protected Setup page within 10
seconds.
Always calibrate the panel before its initial use, and after downloading new firmware.
NOTE: The Calibrate page may also be accessed by pressing down and holding the Reset button on the side of the panel for 9
seconds. For more information, please refer to the Accessing the Setup pages section on page 45.
MVP-9000i - Instruction Manual
Saves all changes and returns to the previous page.
The icon to the left of the Connection Status Icon displays whether the current connection to the Master is Wireless
(image of a radio antenna) or Wired (image of three networked computers).
The icon in the upper-right corner of each Protected Setup page provides a constant visual indication of current
connection status.
Note: a Lock appears on the icon if the panel is connected to a secured NetLinx Master.
This field will always display Static.
Displays the secondary IP address for the panel. The last series of digits may be edited, with a host number added
between 2 and 254.
Displays the subnet mask address for the panel.
Protected Setup Pages
72