To Change A Previously Established Password; To List A New User Within The User Access Section; To Change A User Access Password; To Send Undocking Reports To The Master - AMX MVP-9000i-GB Instruction Manual

Passwords Page
Back:
WiFi/Wired icon:
Connection Status
icon:
In Panel Password
Change:
User Access:
Enable/Enabled:
Report:

To Change a Previously Established Password

1. In the Password Settings page, press the button in the In Panel Password Change section for the particular password to be
changed.
NOTE: Password 5 is protected, and can only be changed by the Administrator.
2. In the Password keyboard, enter the new alphanumeric password.
3. Press Done when complete.
NOTE: Only one of the main passwords may be used to access the Protected Settings page. An individual user password may not
be used to access the Protected Settings page unless it matches one of the main passwords.

To List a New User Within the User Access Section

1. Press a blank button in the User Access section.
2. In the Name keyboard, enter the user's name or nickname and press Done when finished.
3. In the Password keyboard, enter the selected alphanumeric password and press Done when finished.
4. The new user's name will appear in the left column of User Access section. The password will also appear in the right column,
but its characters will be replaced with asterisks.
NOTE: No matter how many characters are in an actual password, the Password column in the User Access section will always
show f ive asterisks.

To Change a User Access Password

1. Press the button corresponding to the user's name in the User Access section.
2. In the Password keyboard, enter the user's password and press Done.
3. Press the password button in the right column of the User Access section.
4. Enter the new password into the Password keyboard and press Done.

To Send Undocking Reports To the Master

From the Password Settings page, press the Report button to enable it. The MVP-9000i will send a report to the Master of
undockings in the form of an "undock-<user>" string.
NOTE: For more information on removing an MVP-9000i from a MVP-WDS-9 Docking Station, please refer to the Unlocking the Touch
Panel on page 24.
MVP-9000i - Instruction Manual
Saves all changes and returns to the previous page.
The icon to the left of the Connection Status Icon displays whether the current connection to the Master is Wireless
(image of a radio antenna) or Wired (image of three networked computers).
The icon in the upper-right corner of each Protected Setup page provides a constant visual indication of current
connection status.
Note: a Lock appears on the icon if the panel is connected to a secured NetLinx Master.
Accesses the alphanumeric values associated to particular password sets.
• The PASSWORD 1, 2, 3, 4 and 5 (protected) buttons open a keyboard to enter alphanumeric values associated to
the selected password group.
Note: Clearing Password #5 removes the need to enter a password before accessing the Protected Setup page.
Use these buttons to access and modify the user name/password combinations required for removing the panel from
a docking station. The number of user access passwords on the panel is limited only by the amount of storage
memory available.
Use the UP/DN buttons to scroll through the list of saved User Access user names and passwords.
NOTE: Enabling User Access disables the Table Dock Latch option on the System & Panel Options page (page 56).
The Enable button allows you to toggle between activating or deactivating the MVP panel requirement of a user to
enter a pre-defined password before removing the panel from a connected docking station:
• Off - does not prompt the user for a password, the docking station just releases the panel when the security
release pushbutton is pressed.
• On - requires that a valid password from the User Access list be entered before removing a panel from a docking
station.
The Report button enables/disables reporting the panel's docking status to the Master.
Protected Setup Pages
74