AMX MVP-9000i-GB Instruction Manual page 18

To swap from a wireless connection to a wired one, simply place the panel in a Table Docking Station or Wall Docking Station. To
swap from a wired connection to a wireless connection, you must first initiate an undock request. This can be done with the undock
button on the Docking Station, or with the Undock Panel button in the System & Panel Options page (please refer to the System &
Panel Options page on page 56). The swap will happen once a valid password is entered (if enabled).
If the panel does not swap to the master immediately, a Confirmation Dialog popup will notify the user (FIG. 4). The user has the
option to force an undock which will cause an offline event, or to cancel the undocking and remain in the dock.
If the swap is completed sometime after the popup is displayed, the popup will disappear automatically. The popup will also
disappear after a 15-second countdown.
"Attempting to Undock" popup window
FIG. 4
NOTE: If an undock is initiated during a VoIP call or Dynamo session, pressing the Yes button ends all VoIP calls in progress and
Dynamo sessions.
After a successful swap from wired to wireless communication, if the panel is not removed from a Table Docking Station after 30
seconds, the dock will automatically lock the latch and swap back to wired communication.
NOTE: The f irmware version of the Master controller must support swapping.
If the user does not want to use the mechanical latch on the TDS or utilize the swapping feature, the Table Dock Latch button may
be disabled or set to Off in the System & Panel Options page.
If an undock is initiated during a VoIP call or a Dynamo session, a warning popup will be displayed (FIG. 5), allowing the user to
proceed with the undock and disconnect sessions or calls, or cancel the undock.
Confirmation Dialog popup window for undocking
FIG. 5
MVP-9000i - Instruction Manual
Introduction
20