AMX MVP-9000i-GB Instruction Manual page 14

MVP-9000i Specif ications (Cont.)
Power Requirements
(While Charging):
Minimum Power
Supply Required:
Power Modes:
Battery Duration:
Panel LCD Parameters:
External Components
Stylus Slot:
MicroSD Card Slot:
Mini-USB Connector: 5-pin Mini-USB connector used for audio output to USB headphones,
DC power port:
Microphone:
Speaker:
Audio Standards:
IR Emitters:
Certifications:
Operating/Storage
Environment
MVP-9000i - Instruction Manual
Panel while charging battery:
• Constant current draw: 2.0 A @ 12VDC
• If panel is mounted onto a TDS or WDS, add 0.1 A to the above figures.
• PS3.0 Power Supply (FG423-30) (included)
• PS-POE-AT High Power PoE Injector (FG423-81) through the Table Docking Station and Wall Docking Station
• ON: All necessary modules are powered up and device remains online with the NetLinx Master.
• SLEEP: Only the backlight will be turned off after the user selectable time of inactivity has elapsed. Panel
resumes the ON mode immediately after being touched.
• STANDBY: Power to all components other than the touch screen is turned off after the user selectable time of
inactivity has elapsed. Device will turn back on by touching the screen. Re-acquiring an AP connection may
require up to 25 seconds. (Standby Mode does not apply if a USB or microSD card is connected to the device.
For more information, please refer to the Picture View section on page 18.)
• SHUTDOWN: Power to all peripherals and components is turned off. The system remains in this mode until it
is restarted by applying power or touching the screen.
• On (continuous use): 5 hours; Standby: 3 days
• 10 hours of normal use, in a combination of On, Sleep, Standby, and Shutdown.
• 3 days of standby use
• Screen resolution: 800 x 480 pixels (HV) @ 60 Hz refresh rate
• Aspect ratio: 16 x 9
• Brightness (luminance): 400 cd/m2
• Channel transparency: 8-bit Alpha blending
• Contrast ratio: 900:1 max.
• Display colors: 16.7M colors (24-bit color depth)
• Dot/pixel pitch: 0.246 mm
• Panel type: TFT Color Active-Matrix (IPS technology)
• Viewing angles:
Vertical: + 85° (up from center) and - 85° (down from center)
Horizontal: + 85° (left from center) and - 85° (right from center)
Slot where the included stylus is stored, located on the left side of the device.
Slot for insertion of standard MicroSD memory cards.
programming, firmware updates, and touch panel file transfer between the PC and the target panel.
Note: When connecting the panel to PC using a CC-USB (or compatible) cable, be sure to power the panel On
before attempting to connect the USB cable from the PC to the mini-USB port on the panel.
2.5 mm port to power the panel away from a Docking Station.
For use with the intercom feature and for calls using SIP.
• Frequency: 20 to 160,000 Hz
• S/N Ratio: More than 58 dB
• 4 Ohm
• 2 Watts 300Hz cutoff frequency
• G.711 sound standard
• 75dB SPL@1m
Transmit IR (transmit only) over 20 feet (6.10 m) from the panel.
• IR emitters on G4 panels share the device address number of the panel.
• Transmits AMX fixed frequencies at 38KHz and 455KHz and third-party
user-programmable frequencies from 20KHz to 1.5MHz
• FCC Class B
• CE
• IC
• VCCI
• C-Tick
• Operating Temperature: 0° C (32° F) to 40° C (104° F)
• Battery Charging Temperature: 0° C (32° F) to 30° C (86° F)
• Operating & Battery Charging Humidity: 20% to 85% RH
• Storage Temperature: -10° C (-14° F) to 60° C (140° F)
• Storage Humidity: 5% - 85% RH
Introduction
16