Unlocking The Touch Panel; Recharging - AMX MVP-9000i-GB Instruction Manual

The MVP-9000i touch panel remains locked in the MVP-WDS-9 until unlocked by the user. This may be done by entering an
appropriate password (please refer to the Passwords section on page 73 for more information), or by pressing the Security Release
button on the front of the device in emergencies.
The station ejects the device top first. The device uses two neodymium rare-earth magnets to keep the MVP-9000i from falling out
of its cradle when the touch panel is angled forward.
MVP-WDS-9-GB Wall Docking Station - Side view
FIG. 10

Unlocking the Touch Panel

For information on removing a touch panel locked into the MVP-WDS-9, please refer to the Undocking from the MVP-TDS-9 or MVP-
WDS-9 on page 28.

Recharging

To recharge the MVP-9000i:
1. Slide the device into the Wall Docking Station cradle bottom-first and make sure the device is fully seated in the Docking
Station (FIG. 11).
MVP-9000i
MVP-WDS-9
Inserting the MVP-9000i into the MVP-WDS-9
FIG. 11
2. Press the top of the MVP-9000i back until it clicks. The touch panel is now locked into the Docking Station, and the station will
automatically charge the device's battery. (Please refer to the Power Management Page section on page 48 to check on the
battery charge status.)
3. To release the touch panel, unlock the touch panel and wait for the Wall Docking Station to pivot the touch panel away from
the wall (FIG. 19).
MVP-9000i - Instruction Manual
Wall Docking Station
MVP-9000i
Security Release button
Accessories
24