Security Settings; Installing Firmware - AMX MVP-9000i-GB Instruction Manual

Security Settings

The Security button on the System & Options page has three settings: Standard, Secure, and DoD. Pressing the button opens the
Panel Security Setting popup window (FIG. 67): :
Panel Security Setting popup window
FIG. 67
Security Prof ile Features
Standard: • Factory default, shipped in this configuration.
Secure:
DoD:
NOTE: A transition from one security mode to another will reset the Protected/Web Control/remote login password to the default
value for the current security mode (please refer to the default passwords above). A transition to Secure or DoD mode will disable G4
Web Control. Although the security password features are immediate, a reboot must occur for all the new security mode features to
take full effect.
For more information on configuring AMX devices for a secure environment, please refer to the guide Security Prof iles: Conf iguring
AMX Devices For Installation Into a Secure Environment, available at www.amx.com.

Installing Firmware

Pressing the Install Firmware button opens a popup window that gives three options for updates and resets (FIG. 68):
Firmware Installation popup window
FIG. 68
If the MVP-9000i needs to be returned to its factory default firmware, press the Factory button. If you have already installed the
latest available firmware version and wish to reinstall a previous version, press the Previous button. If you wish to install new
firmware from a connected microSD card or external USB stick, press the New button.
NOTE: The MVP-9000i automatically detects connected microSD cards and USB thumb drives. If a microSD card or USB thumb drive
containing f irmware is not connected to the device, the New button will be disabled It will only be enabled if it detects a USB drive or
microSD card with a .kit f ile in the correct directory.
For more information on installing firmware upgrades, see Upgrading Firmware on page 80.
MVP-9000i - Instruction Manual
• Default Protected Setup Password is "1988".
• Remote login uses Telnet.
• Default Protected Setup Password is "Amx1234!".
• Minimum password requirement is 8 characters with at least one numeric character.
• Remote login uses SSH.
• Remote login user name is "amx".
• Login failure attempt pauses 4 seconds before another login attempt is allowed.
• After 3 consecutive unsuccessful SSH login attempts, login lockout is enabled for 15 minutes.
• Login and logout audit logging is enabled.
• Default Protected Setup Password is "Amx1234!".
• Minimum password requirement is 8 characters with at least one numeric character, one uppercase character, one lower
case character, and one special character, with no duplicate adjacent characters.
• Remote login uses SSH.
• Remote login user name is "amx".
• Login failure attempt pauses 4 seconds before another login attempt is allowed.
• After 3 consecutive unsuccessful SSH login attempts, login lockout is enabled for 15 minutes.
• Login and logout audit logging is enabled.
• DoD login banner is enabled.
Protected Setup Pages
57