Starting Picture View; Preview Mode And Normal Mode; Picture View Send Command; Seamless Wireless To Wired Swap - AMX MVP-9000i-GB Instruction Manual

Starting Picture View

1. Connect a USB drive to the device or insert a microSD memory card into the microSD memory card slot. Picture View will
automatically recognize all available images on the drive or memory card and start displaying them on the touchscreen.
2. When the images begin to display, touch any place on the touchscreen to open the configuration popup menu (FIG. 3). If no
selection is made, this menu will remain in place for 15 seconds and then disappear. It may be accessed again by touching
anywhere on the touchscreen.
Random / A-Z
Picture View configuration popup menu
FIG. 3
3. On the leftmost red button, select between Rand (images display at random) and A-Z (images display in alphabetical order
based on the name of the file).
4. The four blue buttons allow scrolling through saved images and the rate of display:
The Previous button returns the display to the previously displayed image.

The Stop button stops Page View and returns to the default panel page.

The Pause/Resume button allows the display to stop on one particular image. Press it again to resume the display

procession.
The Next button moves the display to the next stored image. If the MPVP-9000i has not accessed all of the images available

on a USB drive or memory card, Page View will display the last one uploaded to date.
5. On the rightmost red button, select the number of seconds a selected image will be displayed in Picture View. This may be
selected between 5, 10, 15, 30, and 60 seconds.
6. The counter beneath the buttons displays the number of images currently uploaded by the MVP-9000i versus the number
detected on the USB drive or microSD card.

Preview Mode and Normal Mode

Picture View has two modes: Preview Mode and Normal Mode. Preview Mode allows the user to configure Picture View. Once an SD
card or a USB drive containing images is inserted into the panel, the images will begin to display. Touching any place on the display
will result in the configuration popup to slide from the bottom of the display.
Picture View goes into its Normal Mode when the MVP-9000i goes into idle timeout while connected to a USB drive or memory
card.
Normal Mode displays images until the touchscreen or capacitive touch buttons are touched, or some other wakeup event is
detected. When the device goes back into timeout, Normal Mode will return to displaying images until the USB drive or memory
card are removed from the device.

Picture View Send Command

Picture View must be enabled or disabled with the ^PIC Send Command. For more information, please refer to the ^PIC section on
page 117.
NOTE: All images must be in JPEG format. PNG and other image formats cannot be viewed through Picture View.

Seamless Wireless to Wired Swap

The MVP-9000i's unique design allows for wireless as well as wired connectivity with the appropriate Table Docking Station or Wall
Docking Station. To prevent offline events when transitioning between wired and wireless connectivity, the MVP-9000i allows for
seamless swapping. For swapping to work correctly, the Wired (page 59) and WiFi (page 59) network settings must be configured
properly. The current connection mode to the master is indicated by the connection icon in the upper right hand corner of the
setup pages as well as in the Current Connection field in the System Settings page under the Master tab.
Refer to the Miscellaneous MVP Strings section on page 120 for strings that are sent to the master when the panel is docked and
undocked.
NOTE: Swapping between wired and wireless connections is only supported when the Master Mode is set to URL. For more
information, please refer to the System Settings Page on page 58.
MVP-9000i - Instruction Manual
Stop Pause/Resume
Previous
Counter
Next
Timer
Introduction
19