Remove The Old Battery; Install The New Battery - AMX Modero MVP-5200i Operation/Reference Manual

4. Carefully remove the back of the device and detach the battery lead at the battery connector
(FIG. 90). This will allow the back cover to be detached from the device.
FIG. 90 Battery installation and connection diagram

Remove the old battery

Attach the residual voltage discharge adaptor (SAA5966-27-A) to the old battery and
allow any remaining charge to dissipate. Note that the adaptor may become warm to
the touch for up to 12 hours.

Install the new battery

MVP-5200i Modero Viewpoint Widescreen Touch Panel
Peel the hinge cover film from the hinges on either side of the battery before removing the
battery. If the battery is attached to the interior of the device with adhesive tape, carefully pry
the battery free. DO NOT use sharp or edged objects to pry the battery free, as these may
damage the battery or the device. Please dispose of the battery in a proper fashion as required
by municipal or federal regulations.
If the battery comes in a protective metal case, remove the two screws holding the battery case
to the back cover. Carefully remove the battery from the back cover. Please dispose of the
battery in a proper fashion as required by municipal or federal regulations.
Open the plastic bag containing the MVP-BP-5X kit, taking care not to use sharp instruments
near the battery itself.
Attach the new battery to the back cover, either using the two screws used to hold the previous
battery to the cover or with the two replacement screws included with the MVP-BP-5X kit.
Battery Life and Replacement
Battery Connector
171