Upgrading From Previous Firmware - AMX MVP-9000i-GB Instruction Manual

"Firmware upgrade not initiated" notice screen
FIG. 99
6. If you touched the screen to upgrade firmware, the Upgrade In Progress splash screen will appear (FIG. 100).
"Upgrade in Progress" splash screen
FIG. 100
7. If the panel does not detect the KIT file in the directory, access the Setup Pages (page 45), go to the Protected Settings page
(page 55), and access the System & Panel Options page (page 56). If the panel detects the appropriate KIT file, either or both
of the Install Firmware or Install Pages buttons will be enabled. Press either to go through the automatic upload procedure.

Upgrading from Previous Firmware

The MVP-9000i allows the option to revert the device to the previous firmware run before an upgrade. To upgrade the device from
previously loaded firmware:
1. From the Protected Setup page, press the Options button to open the System & Panel Options page.
2. In the System Options section, press the Install Firmware button.
3. In the Firmware Installation popup window (FIG. 68), press the Previous button.
4. The Conf irmation Dialog box (FIG. 101) will ask "Are you sure you want to install the following firmware?" The option to
choose Yes will be enabled after five seconds. Press Yes to load the firmware listed, and No to return to the Firmware
Installation popup window.
Previous Firmware installation confirmation dialog box
FIG. 101
5. If you choose Yes, the device will retrieve the files and then reboot (FIG. 102).
MVP-9000i - Instruction Manual
Upgrading Firmware
81