Audio Page; Wav Files - Supported Sample Rates - AMX MVP-9000i-GB Instruction Manual

Display Page (Cont.)
Panel Brightness:
Inactivity Page:
Flyout Menu:

Audio Page

The Audio page allows adjustment of volume levels and panel sounds settings (FIG. 50).
Audio pages
FIG. 50
Audio Page
Back:
WiFi/Wired icon:
Connection Status
icon:
Button Sounds:
Intercom
Mic Level:
Volume:
Master Volume:
WAV f iles - Supported Sample Rates
The following sample rates for WAV files are supported by MVP-9000i panels:
Supported WAV Sample Rates
• 48000 Hz
• 44100 Hz
• 32000 Hz
MVP-9000i - Instruction Manual
Sets the display brightness and contrast levels of the panel.
Press the Brightness Up/Down buttons to adjust the brightness level. Range = 0 - 100.
Note: Be careful not to turn down the brightness too low to be able to see the Setup page.
Indicates the length of time that the panel can remain idle before automatically flipping to a pre-selected page.
• Press the Up/Down buttons to increase/decrease the Inactivity Page Flip Timeout setting. Range = 1, 2, 5, 10, 15,
30 minutes, 1, 2, 3, 4 hours.
• Set the timeout value to 0 to disable Inactivity Page mode.
Note: The touch panel page used for the Inactivity page flip is named within a small Inactivity Page f ield below the
buttons. The default reading is "MAIN".
This switch controls the flyout menus on the capacitive touch buttons on the left of the screen. "On" allows use of
any flyout menus connected to the buttons, and "OFF" disables them.
Saves all changes and returns to the previous page.
The icon to the left of the Connection Status Icon displays whether the current connection to the Master is Wireless
(image of a radio antenna) or Wired (image of three networked computers).
The icon in the upper-right corner of each Setup page provides a constant visual indication of current connection
status.
Note: a Lock appears on the icon if the panel is connected to a secured NetLinx Master.
• Activating the Hit On button plays a default sound when you touch an active button. Touch the field a second time
to switch the button to Hit Off, which disables the sound.
• Activating Miss On button plays a default sound when you touch a non-active button or any area outside of the
active button. Touch the field a second time to switch the button to Miss Off, which disables the sound.
• The Test button plays a test WAV/MP3 file over the panel's internal speakers.
Adjusts the volume level on the intercom's microphone:
• Use the Up/Down buttons to adjust the microphone level (range = 0 - 100%). Press the Mute On button to mute
the microphone and press it again (switching the button to Mute Off) to enable it.
Adjusts the volume level on the touch panel's speaker:
• Use the Up/Down buttons to adjust the speaker level (range = 0 - 100%). Press the Mute On button to mute the
speaker and press it again (switching the button to Mute Off) to enable it.
This section allows you to alter the current master volume level:
• Use the Up/Down buttons to adjust the volume level in one-percent increments (range = 0 - 100%).
• The Master Volume readout indicates the current volume level. Press the Up/Down buttons to adjust the volume
level in one-percent increments (range = 0 - 100%).
• The Mute On button toggles the Mute feature. Press it again to switch it to Mute Off.
• 24000 Hz • 12000 Hz
• 22050 Hz • 11025 Hz
• 16000 Hz • 8000 Hz
Setup Pages
47