Remove The Old Battery; Install The New Battery; Reconnecting The Battery To The Device - AMX Modero ViewPoint MVP-5200i Operation/Reference Manual

Battery Life and Replacement
FIG. 90 Battery installation and connection diagram

Remove the Old Battery



Attach the residual voltage discharge adaptor (SAA5966-27-A) to the old battery and
allow any remaining charge to dissipate. Note that the adaptor may become warm to
the touch for up to 12 hours.

Install the New Battery




Reconnecting the Battery To The Device

1.
On the back cover, make sure that the battery connector wiring runs to the right and that the protective
film on the battery case has been removed. Make sure that the excess battery wiring fits in the space to the
bottom left of the battery placement (FIG. 91). The battery wiring may be looped around the support if
necessary; make sure that the battery is not crimped or damaged upon closure of the case.
FIG. 91 Path of excess battery wiring
150
Peel the hinge cover film from the hinges on either side of the battery before removing the battery.
If the battery is attached to the interior of the device with adhesive tape, carefully pry the battery
free. DO NOT use sharp or edged objects to pry the battery free, as these may damage the battery
or the device. Please dispose of the battery in a proper fashion as required by municipal or federal
regulations.
If the battery comes in a protective metal case, remove the two screws holding the battery case to
the back cover. Carefully remove the battery from the back cover. Please dispose of the battery in a
proper fashion as required by municipal or federal regulations.
Open the plastic bag containing the MVP-BP-5X kit, taking care not to use sharp instruments near
the battery itself.
Attach the new battery to the back cover, either using the two screws used to hold the previous
battery to the cover or with the two replacement screws included with the MVP-BP-5X kit.
Excess battery wiring path
MVP-BP-52 battery placement
Battery Connector
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom