AMX MVP-9000i-GB Instruction Manual page 36

Completing the Found New Hardware Wizard
FIG. 33
When an IP address is assigned to the usb0 interface on the device, Windows XP will make an attempt to assign an IP address to the
corresponding interface on the Windows side. Usually, this IP address is a random value and in a totally different subnet. The user
may set the Windows network properties for the Ethernet over USB interface to have a specific address whenever the Windows XP
system detects an MVP-9000i with an assigned IP address.
In Windows XP:
1. From the Windows XP desktop, click on Start > Settings > Network Connections. This opens a window listing the currently
active network connections.
2. Select the connection that is specific to AMX USB Device Link.
3. Right click and select Properties.
4. In the Local Area Connection 3 Properties window (FIG. 34) under the General tab, select Internet Protocol (TCP/IP) and click
on Properties.
Local Area Connection 3 Properties
FIG. 34
5. In the new window:
Select Use the following IP Address.

Under IP address, provide an IP address (ensure that it is in the same subnet as the IP address given to the usb0 interface

on the MVP-9000i).
Under Subnet mask, set the suitable subnet mask. Make sure that the host machine has the same subnet mask. (The subnet

mask for USB connection is 255.255.0.0, which is not user-configurable.)
Click on OK'

6. In the Local Area Connection 3 Properties window, click on OK.
The user should now be able to run any TCP/IP application between the two systems.
MVP-9000i - Instruction Manual
Configuring Communication
38