Installing The Mxr-1001; Overview; Required Accessories (Not Included); Unbox The Mxr-1001 And Remove Shipping Screws - AMX MXR-1001-SL Installation & Hardware Reference Manual

Installing the MXR-1001

Overview

Read these instructions in their entirety before beginning the installation. The installation requires specific steps to be performed
the specified order.
CAUTION:
installation. Installation must conform to all local codes. This product may not be installed by the end-user.
NOTE: Due to the weight of the MXR-1001, this installation requires TWO INSTALLERS.

Required Accessories (Not Included)

Straight-Cut Router bit: Freud 12-128 or Whiteside 1072 (0.5" or 12mm / 12.7mm OD)

Guide Bushing: Woodcraft 144693 (.75" or 19 mm OD)

Bushing Lock Nut: Woodcraft 144696


1) Unbox the MXR-1001 and Remove Shipping Screws

1. Carefully remove the MXR-1001 from the shipping box and remove packing materials. Note that the MXR-1001 ships with two
Shipping Screws installed on the bottom surface of the Motor (FIG. 7):
MXR-1001 BOTTOM View - remove shipping screws before installation
FIG. 7
2. Remove the Shipping Screws before installing the MXR-1001.

2) Select a Suitable Location

Ensure that the MXR-1001 will not interfere with the normal use of the work space when installed, both above and below the
mounting surface. For example, ensure that the Motor chassis does not interfere with the user's legs when seated at the table. Also,
ensure that other devices installed in proximity to the MXR-1001 will not interfere with the installation and use of the MXR-1001.

Mounting Surface Requirements

Above Mounting Surface (HWD):
Below Mounting Surface (HWD):
Mounting Surface Thickness:
NOTE: Use the included surface extender for surfaces thicker than 2" (50mm). Refer to the MXR-1001 Hardware Installation Guide
for details.
MXR-1001 - Installation & Hardware Reference Manual
This installation requires specif ic woodworking skills. Only a professional, AMX-qualif ied installer should perform this
REMOVE SHIPPING SCREWS BEFORE INSTALLING
9.57" x 10.55" x 4.53" (243mm x 268mm x 115mm)
15.37" x 12.04" x 6.78" (391mm x 306mm x 173mm)
Min: 0.5" (12.7mm) / Max: 2.0" (50mm)
Installing the MXR-1001
12