Battery Life And Replacement; Overview; Important Notes - AMX MVP-9000i-GB Instruction Manual

Battery Life and Replacement

Overview

The battery powering the MVP-9000i is designed for upwards of 300 deep discharge rechargings. Regular shallow rechargings will
extensively increase expected battery life, and the device should be stored in either the Table Docking Station or the Wall Docking
Station when not in use to keep it at an optimum charge. The battery has reached its effective end of life after it can no longer hold
more than a 70 percent charge.
CAUTION:
charged properly. Improper use can result in serious injury, f ire, or death. Please read and understand the following warnings. If you
have any questions or concerns with this product, please contact your AMX sales representative.
NOTE: This installation requires opening the case of the MVP-9000i and working within its internal components. If you are unwilling
or unable to replace the battery, please return the device to AMX for battery replacement.
WARNING: Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used Batteries According to the Instructions.
WARNING: Misuse of a Lithium-Polymer battery may result in overheating, f ire, or explosion!
Safety Information:
Do not dismantle, open, or shred the battery.
Do not short circuit the battery. Do not store batteries haphazardly in a box or drawer where they may short circuit each other or
be short circuited by conductive materials.
Do not remove a battery from its original packaging until required for use.
Do not expose batteries to heat or f ire. Avoid storage in direct sunlight.
Do not subject the batteries to mechanical shock.
In the event of a cell leaking, do not allow the liquid to come into contact with the skin or eyes. If contact has been made, wash
the affected area with copious amounts of water and seek medical advice.
Insure battery connector is aligned and installed correctly.
Store the batteries in a dry place with temperature between 0° C (32° F) and 40° C (104° F).
Do not maintain the battery on charge when not in use.
Note that batteries give their best performance when they are operated at normal room temperature (20°C/68°F) ± 5°C/9°F).
When disposing of batteries, keep cells or batteries of different electrochemical systems separate from each other.
Charging
Use only with approved AMX charger.
NOTE: Care must be taken to install the battery without damaging the battery.

IMPORTANT NOTES!

Lithium-Polymer battery technology degrades in capacity over time, unless the battery is periodically charged and

discharged. AMX recommends installing all Lithium-Polymer batteries in functional AMX products within 6 months of
receipt.
Charging Lithium Polymer batteries at high temperature will reduce the battery life. Industry guidelines dictate that

batteries should not be charged at temperatures above 45° C (113° F). The temperature is determined by a combination
of the ambient temperature where the panel is located, plus temperature increases normally occurring inside electronic
devices containing batteries. AMX has implemented battery temperature monitoring features to maximize the rate of
battery charging, while staying within industry temperature guidelines.
Battery charge times will increase in installations where the room temperature is above 25° C (77° F), and may be
temporarily suspended at room temperatures above 30° C (86° F).
temperature has fallen to appropriate levels. Minimizing the display backlight intensity and turning off the backlight during
periods of non-use will also yield faster charge times.
NOTE: Please dispose of all used batteries in a proper fashion as required by municipal or federal regulations.
NOTE: Prior to battery removal, run the device until the battery is completely discharged.
MVP-9000i - Instruction Manual
Lithium-Polymer batteries are small, compact, and ideal for providing long lasting power. However, they must be used and
Battery Life and Replacement
Battery charging will automatically resume once the
135