Loading Paper In Tray T1 (Inserter) - Fuji Xerox ApeosPort-VII C7788 Quick Reference

6
Likewise, load the remaining envelopes and align the envelopes in the arrow direction (1).
Hold the short-side paper guide on the left side and slide it to the desired paper size (2).
Important
Do not load paper exceeding the maximum fill line. It might cause paper jams or device malfunctions.
If the number of sheets is 10 or less, the paper guides touch too tightly against the paper, causing the paper
to deform and resulting in paper jams.
When loading envelopes, neatly align all edges. If the envelopes loaded are tipped, reduce the number of
envelopes loaded.
Position the paper guides correctly to match the paper size. If the position of the guide is not correct, the
paper may not be fed properly, causing paper jams.
7
Push the tray in gently until it stops.
Note
When removing the Post Card Kit from the tray, completely loosen the screw before removing the kit. Place
the removed Post Card Kit back to its original location (1). Then, tighten the screw (2).

Loading Paper in Tray T1 (Inserter)

The following describes the procedure for loading paper in Tray T1 (Inserter).
Tray T1 (Inserter) allows you to load paper (blank, copied paper, etc.), which will only be
used as separators and covers, so that the device does not output on the paper loaded in
this tray.
Note
When adding paper to Tray T1 (Inserter), remove any paper remaining in the tray, add it to the stack of paper
to be added, and then load all of the paper into Tray T1 (Inserter) at once.
Saddle Stitch / Bi-fold can be performed only when using paper of the same size as body pages (paper sheets
delivered from the printer unit).
Loading Paper
85