Loading Paper In Tray 6 (Hcf) (Optional) - Fuji Xerox ApeosPort-V 5070 Administrator's Manual

3
Adjust the paper guides to align the edges of
the paper loaded.
4
Instruct a copy or print job.

Loading Paper in Tray 6 (HCF) (Optional)

The following describes the procedure for loading paper into Tray 6 (HCF) (optional).
When the machine runs out of paper during copying or printing, a message is displayed on
the touch screen. Add paper according to the displayed instructions. Copying or printing is
automatically resumed when paper is added.
Note • Fan the paper well before loading paper in a tray. It prevents paper from sticking to each other and
For information about changing the paper size and orientation, refer to "Changing the Paper Size for Tray 6 (HCF)
(Optional)" (P.56).
1
Pull out the Tray 6 until it stops.
Important • While the machine is processing a job, do not
• Do not add a new stack of paper on top of
2
Load and align the edge of the paper against
the right edge of the tray with the side to be
copied or printed on facing up.
Important • Do not load paper above the maximum fill
3
Push the tray in gently until it stops.
Important • When pushing the paper tray in, do it slowly. If the tray is pushed with too much force, it might cause
reduces paper jams.
pull out the tray that the job uses.
the remaining paper in the tray to prevent
paper jams or any other troubles. First,
remove the remaining paper from the tray,
and then load the new stack of paper.
line. It might cause paper jams or machine
malfunctions.
machine malfunctions.
Loading Paper
2
53