Users' Programming Menus; Changing Own Code - Teletek electronics ECLIPSE 8 User's Operation Manual

ECLIPSE 8/ 16/ 32 Series – User Operation Manual

4. USERS' PROGRAMMING MENUS

There are no default codes for ordinary users in the system. The Manager in the system
can set new codes and allow certain users to have manager rights (for ECLIPSE 32).
To enter user programming mode, enter in consecutive order:
* Code without manager rights.
Quick table for Users' Programming Menu
Address
Number
1
2
3
4

4.1 Changing own code

Every user without manager rights in the system can change only his/her own access
code. To change the code the user needs to enter the currently valid code:
Main screen
User Code
After confirming the new code with the ENTER button, if the code is accepted, the
keyboard emits a confirmation beep and will return to code entry screen. If the entered
code is already being used in the system (a valid user or ambush code), the keyboard
emits a rejection beep. For LCD keyboards there is also "Invalid" message on the screen.
The system returns to address entry screen.
Going back to the main screen is done by pressing the CANCEL.
Code*
Programming
parameter
Changing own code
Memory LOG view
Chime
Zone bypassing
Address
1-digit address
ECLIPSE ECLIPSE
8




New code
18
ECLIPSE
16 32








Save