Checking The Bypassed Zones - Teletek electronics ECLIPSE 8 User's Operation Manual

To review the system troubles press the TROUBLE button. In TROUBLE MODE viewing
the TROUBLE button starts blinking. To exit TROUBLE MODE press CANCEL or wait 30
seconds for the system to leave this mode automatically.
For LED 8 and LED 16 keyboards the system troubles are indicated with permanently lit
TROUBLE LED. To review the system troubles single press the ENTER button.
The indication for system trouble will stop automatically after the trouble is restored.
The system troubles are displayed with permanently lit on number on the LED display and
with a text message on LCD displays. The text messages are displayed one by one or
can be scrolled manually with the arrows.
The list with possible system troubles is shown in the table below:
LED LCD

1. AC Loss
2. Batt Тrouble


3. Blown fuse
4. Tel.lineTRBL or

Comm.Fail

5. Tamper
6. Sysbus еrr


7. FIRE LINE ERROR*

8. SOUND Fault*
* Not supported in ECLIPSE 8/ 16 control panels.

3.8 Checking the Bypassed Zones

According the used keyboard the indication for bypassed zones differs.
Keyboard Indication and checking the bypassed zone
The BYPASS LED is lit. In order to check the bypassed zones you need to
press the ENTER button once. The numbers of the bypassed zones are lit,
LED 8/ while the BYPASS LED blinks.
LED 16 Note: The LED 8 keyboard has indication for bypassing 01 to 08, and LED
16 – for 01 to 16 zones. If there are bypassed zones out of their range,
they are not shown on the screen.
The BYPASS button is lit. In order to check the bypassed zones you need
LED 32 to press the BYPASS button once. The numbers of the bypassed zones
are lit, while the BYPASS button blinks.
The BYPASS button is lit. In order to check the bypassed zones you need
LCD 32 /
to press the BYPASS button once. Information about the first bypassed
LCD 32
zone is shown on the display, while the other zones can be checked with
Sensitive
the arrow buttons, the BYPASS button blinks.
ECLIPSE 8/ 16/ 32 Series – User Operation Manual
Description
Main power supply loss.
Low battery charge or back-up battery is missing.
Blown out fuse.
Telephone line loss. Communication with monitoring
station failed.
Open TAMPER switch in the system.
System buss error – short circuit in the system bus
line or lost device.
The fire line connection is broken up.
Trouble in the siren line.
17