Deleting A User Card - Teletek electronics ECLIPSE 8 User's Operation Manual

ECLIPSE 8/ 16/ 32 Series – User Operation Manual
The card is recognized on the LCD display and its 10-digit unique code is shown on
screen.
If the registration of a card to a user code is successful, after pushing the ENTER button,
a confirmation beep is heard. If the card is associated to a different user, an "Invalid"
message is shown on screen and a rejection signal is heard.
LED 16 and LED 32
The card is associated
There is no card
associated to the code
Put the card over
the reader*
The card is recognized on the LED display with digits 1 to 8 permanently lit.
If the registration of a card to a user code is successful, after pushing the ENTER button,
a confirmation beep is heard. If the card is associated to a different user, a rejection signal
is heard.
LED 8
Enter at the address 11 and choose a user number - the LED for zone 1 is blinking on the
display. The registered user card is indicated with digit buttons 1 to 9 lighting on.
* Note:
The proxy reader can be a separate device or built in the keyboard (keyboards LED32
PR, LCD32 PR). The built in proxy reader is situated between the MEMORY, ENTER, "9"
and TROUBLES buttons.
In LCD 32S the card reader is situated in the right bottom corner and is indicated with a
"key" pictogram.

5.13 Deleting a User card

Deleting a card is done again at address 11, after entering a manager code:
Press and hold
Address
for 2-3 sec.
Manager code User
number
Depending on the keyboard used, the visualization on screen is as follows:
LCD 32 and LCD 32 Sensitive
Press and hold
Card is deleted
Associated card
for 2-3 sec.
31