Creating And Changing User Codes; Deleting User Codes; Memory Log Review By Manager - Teletek electronics ECLIPSE 8 User's Operation Manual

17
18
90
91
92
93
* For LCD keyboards only
** For LCD 32 Sensitive keyboard only

5.1 Creating and Changing User codes

Creating new and changing existing user codes is done at address 01. To create a new or
change an existing use code the system Manager enters in consecutive order:
Main screen
Manager code
Attention: In ECLIPSE 32 control panel you cannot create or change other Manager
codes, so before that go to address 06 and disable the 8.Manager right for the regular
users.
After confirming the new code with the ENTER button, if the code is accepted, the
keyboard emits a confirmation beep and goes back to the user number screen. If the
entered code is already being used in the system (a valid user or ambush code), the
keyboard emits a rejection beep. For LCD keyboards there is also "Invalid" message on
the screen. The system goes back to address entry screen.
To return to the main screen press the CANCEL button a few times.

5.2 Deleting User codes

The complete removal of user (or manager) code is done by deleting its rights (address
06) and its associated areas (address 07). If only the rights are deleted the code will
remain active but with limited functions – it could be used only to check the memory log
and troubles in the system and to arm the associated areas in Full arm mode. To remove
the code completely the code's associated areas need to be deleted as well – see items
5.6 and 5.7.

5.3 Memory LOG review by Manager

Viewing the events in the memory log is done at address 02 or by pressing the MEMORY
button, after manager code has been entered:
Manager code
ECLIPSE 8/ 16/ 32 Series – User Operation Manual
Remote access attributes
Manual test
Buzzer level
Brightness
Scroll speed*
Sensitive backlit**
Address
Address






User
number
OR
Manager code
23
 
 
 
 
 
 
New code
Save