Disarming Via Stand-Alone Proxy Reader; Stopping The Sounders; Panic Buttons; Ambush Code - Teletek electronics ECLIPSE 8 User's Operation Manual

ECLIPSE 8/ 16/ 32 Series – User Operation Manual
When using LED keyboard, after the proxy card is recognized the numbers of the armed
areas blink in red.
The system will wait for the number of the areas to be entered.
Sequence for disarming via card reader:
Entry 2 signals Area
time Numbers
Notes:
Use the button "0" to disarm all associated to the user code areas.

3.3.3 Disarming via stand-alone proxy reader

Place and hold the card in front of the reader until all LED indicators are off. Remove the
card to disarm the system – the proxy reader will beep for confirmation.

3.4 Stopping the Sounders

A triggered alarm can be reset by entering a valid user code.
Note: The user code must have assigned rights to operate with area where the alarm
event is triggered off the sirens.

3.5 Panic Buttons

By using a combination of buttons the user can send an alarm signal without triggering the
siren off. To send an alarm signal:
• For "FIRE ALARM" signal, press and hold the 7+9 buttons for 2 seconds.
• For "MEDICAL ALARM" signal, press and hold the 4+6 buttons for 2 seconds.
• For "PANIC ALARM" signal, press and hold the 1+3 buttons for 2 seconds.

3.6 Ambush Code

Ambush code is a system code which is used to disarm the system, but it also sends an
"alert" signal to the monitoring station. It is used when the user is forced to disarm the
system.
The Ambush code is formed by increasing the last digit of the user's personal code by 1.
If the last digit is 9, it is replaced by 0.
Personal code: 4615 → Ambush code: 4616
For example:
Personal code: 4619 → Ambush code: 4610

3.7 Technical Troubles Review

In case of system trouble the TROUBLE button lights on permanently. On the LCD
keyboards text message "Trouble [TRBL]" is displayed.
16