Arming All Available Areas In The System; Viewing The Status Of The Areas - Teletek electronics ECLIPSE 8 User's Operation Manual

ECLIPSE 8/ 16/ 32 Series – User Operation Manual

3.1.4 Arming All Available Areas in the System

The user can perform arming of all available for operation areas in system. To arm all
areas use button "0". According the way of arming – with or without entering a user code –
the number of the armed areas can be different.
With a user code
When using a code for arming, the user can arm at the same time only all associated to
its own code areas. The user can be allowed to operate with one, several or all areas in
the system – that depends on the programmed for the code at address 07 in the
Managers menu.
Quick Arming (Without a user code)
When performing quick arming, without entering code, the user can arm at the same time
all available for operation areas in the system.
Sequence of buttons for activation of all areas in the system:
With code
Code
Arming
type

3.1.5 Viewing the Status of the Areas

The user can check-up what is the arming status of every one available area in the
system. The check-up is different and depends on the used control keyboard.
LED Keyboards
When the system is armed the numbers of the armed areas are lit in red.
At LED 8 keyboard, the DISARM button is off, and the quick button of the used arming
mode lights on in red.
At LED 16 and LED 32 keyboards, the used arming mode is checked after entering a valid
code and area number.
Sequence of buttons for checking-up the area status:
Code
Note:
LED 16: The two area numbers are named A and B. To check the area arming mode use
the buttons with arrows and the respective area name.
Note: The button is used in the previous design of the keyboards and LED16.
( )
Exit
Time
Area
Number
The quick button of the used
Quick arming
Push for 2-3
seconds
Full Stay Sleep
( )
Arming type is on in red
12
( )
Exit
Time
Exit