Cloning Users - Teletek electronics ECLIPSE 8 User's Operation Manual

ECLIPSE 8/ 16/ 32 Series – User Operation Manual
LED 16 and LED 32
Press and hold
Card is deleted
Associated card
for 2-3 sec.
LED 8
Enter at the address 11 and choose a user number - the LED for zone 1 is blinking on the
display. The registered user card is indicated with digit buttons 1 to 9 lighting on. Press
and hold for 2-3 second the button "0".
Note:
No confirmation is necessary after deleting of a user card. You cannot reject the operation
with pressing the CANCEL button. To register the card again, follow the steps in item
5.12.

5.14 Cloning Users

Attention: This menu is available for ECLIPSE 32 control panel only.
This is an address for copying (cloning) of attributes, rights, associations, time slots and
rights for work with proxy cards. The address allows the settings of one user code to be
copied to one or more users, which saves the need to program setting for every user
separately.
Cloning is done at address 13, after entering manager code:
Address
Manager code
Depending on the keyboard used, the visualization on screen is as follows:
LCD 32 and LCD 32 Sensitive
Code numbers:
Enter consecutively
Address 13
Source First Last
code numbers
The cloning process starts by entering the number of the code that will be cloned
("Source"). After that the number of the first code in the series of codes which will accept
the settings of the source is entered (First). In the end the last code in the series of codes
is entered (Last).
For example, if you want the settings of code 02 to be cloned to codes 03 to 10 you need
to enter: [02]> [03] [10].
If only one code is to accept the settings of the source, its number is entered both as
"First" and "Last" in the series.
32