Registering A User Card - Teletek electronics ECLIPSE 8 User's Operation Manual

ECLIPSE 8/ 16/ 32 Series – User Operation Manual
Depending on the keyboard used, the visualization on screen is as follows:
LCD 32 and LCD 32 Sensitive
The card can disarm and arm in The card can disarm and arm in
SLEEP ARM mode
FULL ARM mode
By pressing a digit buttons with the number of an option, it is alternatively enabled or
disabled. The option is enabled when the digit is visible on screen. The option is disabled
when the symbol "*" is shown.
LED 16 and LED 32
The card can disarm and arm in
The card can disarm and arm in
SLEEP ARM mode
FULL ARM mode
By pressing a digit buttons with the number of an option it is alternatively enabled or
disabled. The option is enabled when the digit is lit on the display. The option is disabled
when the digit is not lit.
LED 8
Enter at the address 10 and choose a user number - the LED for zone 1 is blinking on the
display. The digit buttons corresponding to the set proxy attributes are on. To change
settings press the respective button number according the table above.
The final choice is confirmed by pressing the ENTER button.

5.12 Registering a User card

Registering a user card is done at address 11, after entering manager code:
Address
Manager code User
Put the card over
number
the reader*
Depending on the keyboard used, the visualization on screen is as follows:
LCD 32 and LCD 32 Sensitive
There is no card The card is registered with a
Put the card over
associated to the code 10-digit unique code.
the reader*
30