Associating Area Numbers To User - Teletek electronics ECLIPSE 8 User's Operation Manual

ECLIPSE 8/ 16/ 32 Series – User Operation Manual
1. Disarm
2. Stay and Sleep
Arm
3. Zone Bypass
4. Programming
5, 6 and 7 are not used
8. MANAGER in
the system
Depending on the keyboard used, the visualization on screen is as follows:
LCD 32 and LCD 32 Sensitive
All attributes are enabled
By pressing the respective digit button the attribute is alternatively enabled or disabled.
The attribute is enabled when the digit is visualized on the screen. Disabled attributes are
marked with "*".
LED 16 and LED 32
All attributes are enabled
By pressing the respective digit button the attribute is alternatively enabled or disabled.
The attribute is enabled when the respective digit on the screen is lit.
LED 8
Enter at the address 06 and choose a user number– the LED for zone 1 is blinking on the
display. The digit buttons corresponding to the assigned attributes are on. To disable an
attribute press the respective number – the button is off, meaning the attribute is disabled.
The final choice is confirmed by pushing the ENTER button.
Note: If all attributes for a certain user code are disabled it does not get deleted from the
system and it can be used for FULL ARM, viewing the memory log and system troubles.

5.8 Associating Area numbers to User

Attention: This menu is available for ECLIPSE 16/ 32 control panels.
Associating areas to user codes is dome at address 07, after entering manager code:
The user code can disarm the system.
The user code can arm the system in STAY and SLEEP mode.
The user code can bypass zones in the protected site.
The user code has access to the user programming menus.
The user code has manager attributes in the system and has
access to the Manager programming menus.
Note: When attribute 8. Manager is set, attribute 4. Programming
also needs to be set!
Attribute 8 is disabled
Attribute 8 is disabled
26