Arming Via Stand-Alone Proxy Reader; Disarming; Disarming Via Keyboard; Disarming Via Built-In Card Reader In A Keyboard - Teletek electronics ECLIPSE 8 User's Operation Manual

The built-in card reader in LCD 32 Sensitive keyboard is situated in the right bottom
corner on the front panel and it is marked with a "key" pictogram.

3.2.2 Arming via Stand-alone Proxy Reader

The User can arm the system via stand-alone proxy reader in one of the following arming
modes, which are programmed in advance from the system engineer:
- "Full ARM" – of all available areas in the system
- "MODE А" – a specific combination of arming modes for the used areas
- "MODE В" – a specific combination of arming modes for the used areas
To arm the system in one of the listed above arming modes, the User has to place and
hold the proxy card in front of the stand-alone reader until activation of the respective LED
indication:
- "Full ARM" – RED LED is lighting on
- "MODE А" – GREEN LED is lighting on
- "MODE В" – YELLOW LED is lighting on
The reader beeps at every changing of the arming mode. When the LED indication of the
selected arming mode is on the User has to remove the card. After the exit time is over
the LED of the activated arming mode lights on permanently.
Note: Ask you installer for details about the arming modes set for your system.

3.3 Disarming

Every user can disarm only those areas associated for operation to its personal code.
Note: Certain users may not be permitted to disarm the system.

3.3.1 Disarming via keyboard

The user can disarm one, several or all areas at the same time.
Sequence for disarming via keyboard:
Entry
time
Notes:
Use the button "0" to disarm all associated to the user code areas. Note: The
is used in the previous design of the keyboards and LED16.

3.3.2 Disarming via built-in card reader in a keyboard

Disarming with proximity card is possible and when there is a proxy reader built-in in a
keyboard. To disarm the system the user needs to put the card in front of the reader but
not further than 1 cm.
When using LCD keyboard, after the proxy card is recognized, the numbers of the areas
and their current status is shown on the display.
ECLIPSE 8/ 16/ 32 Series – User Operation Manual
( )
Code
15
Area
2 signals
Numbers
button