Setting The Time - Teletek electronics ECLIPSE 8 User's Operation Manual

ECLIPSE 8/ 16/ 32 Series – User Operation Manual
LED 16 and LED 32
After entering address 13, digit 15 on the display blinks, while digit 16 is permanently lit –
the system indicates that it is expecting entering of "Source" code. After entering the first
digit of the code – digit 15 is lit permanently, while digit 16 blinks. The second digit of the
"Source" code is entered. The system now expects entering the "First" code, followed by
"Last" code. The indication is the same.
LED 8
Not supported programming of this address.
The cloning procedure is started with pressing the ENTER button.

5.15 Setting the Time

Setting the time is done at address 14, after entering manager code:
Address
Manager code
Time
[HH: ММ]
Depending on the keyboard used, the visualization on screen is as follows:
LCD 32 and LCD 32 Sensitive
With the help of the digit buttons enter hour and minutes in the format [HH:ММ] – hour
from 00 to 23 and minutes from 00 tо 59.
LED 16 and LED 32
After entering address 14, digit 15 on the display blinks, while 16 is lit permanently – the
system indicates that it expects entering an hour from 00 to 23. Enter the current hour.
After entering the first digit, on the display 15 is lit permanently, while 16 blinks. After the
second digit is entered, 15 blinks again, while 16 is lit permanently – the system indicates
that it expects entering minutes from 00 to 59. The indication is the same.
LED 8
After entering address 14, digit 1 on the display blinks, while 2, 3 and 4 are lit permanently
– the system indicates that it expects entering the new time in the format [HH:ММ] – hour
from 00 to 23 and minutes from 00 tо 59. Enter in sequence the new time. You can review
the entered time using the arrow buttons – the set value at the respective position is
indicated with a lit on digit button.
The entered time is confirmed by pressing the ENTER button.
33