Setting Margins - MIMAKI JV400-LX Series Operation Manual

Setting Margins

Set a non-printing area along the right and left edges of the media.
The offset value against the standard margin 15mm is set hereupon.
• When you give priority to the setting at the RIP software side, make the setting value "Host".
• You cannot specify the margins at the attached RIP software (RasterLinkPro). When you use the
RasterLinkPro, if you set this machine to "Host", printing will be performed in "Margins for right and left
off set value= 0 mm" status.
1
Press the
2
Press the
3
Press
4
Press the
5
Press
• Set the margins for the left of the media.
To enable the margins specified in your RIP, select "Host".
Set Value :HOST or -10 to 85mm (in 1mm increment)
6
Press the
7
Press
• Set the margins for the right of the media.
To enable the margins specified in your RIP, select "Host".
Set Value :HOST or -10 to 85mm (in 1mm increment)
8
Press the
9
Press the
• Pay attention to that printing may start on the media press if a right and left margin is set to 5 mm or
less when the media press is used in printing.
key in LOCAL.
key.
to select [MARGIN].
key.
to set the left margins.
key.
to set the right margins.
key.
key several times to end the setting.
F UNC T I ON
S E T UP [ EN T ]
S E T UP
F E ED COMP . [ EN T ]
S E T UP
MARG I N [ EN T ]
L E F T
= 0 mm
L E F T
= HOS T
R I GH T
= 0 mm
R I GH T
= HOS T
S E T UP
MARG I N [ EN T ]
1
1
3
5
6
3-4